Skip to Content
Reveni Labs
Shop
Contact
Policies
User Manuals
Shipping
Instagram Links
About
0
0
Reveni Labs
Shop
Contact
Policies
User Manuals
Shipping
Instagram Links
About
0
0
Shop
Contact
Policies
User Manuals
Shipping
Instagram Links
About
Shop 120 Film Cutter Guide
IMG_0304-LR.jpg Image 1 of 6
IMG_0304-LR.jpg
IMG_0306-LR.jpg Image 2 of 6
IMG_0306-LR.jpg
IMG_0312-LR.jpg Image 3 of 6
IMG_0312-LR.jpg
IMG_0313-LR.jpg Image 4 of 6
IMG_0313-LR.jpg
IMG_0314-LR.jpg Image 5 of 6
IMG_0314-LR.jpg
IMG_0315-LR.jpg Image 6 of 6
IMG_0315-LR.jpg
IMG_0304-LR.jpg
IMG_0306-LR.jpg
IMG_0312-LR.jpg
IMG_0313-LR.jpg
IMG_0314-LR.jpg
IMG_0315-LR.jpg

120 Film Cutter Guide

CA$20.00
Sold Out

This 3D-printed guide works to keep your film and scissors at a 90 degree angle, and helps to make the edge of the frames easier to spot so you can cut it in the right place. Can be used over a table with a film strip, or with the strip hanging up (my preferred way to cut film).

The jig uses five neodymium magnets to hold the scissors in place, making their alignment much easier.

The finger loops can be swapped from side to side to match your scissors, depending on which way the blades overlap.

Your scissors must be made of steel which magnets can stick to. Cotton gloves are a help too, to help you hold the film in place and avoid fingerprints/grease.

Add To Cart

This 3D-printed guide works to keep your film and scissors at a 90 degree angle, and helps to make the edge of the frames easier to spot so you can cut it in the right place. Can be used over a table with a film strip, or with the strip hanging up (my preferred way to cut film).

The jig uses five neodymium magnets to hold the scissors in place, making their alignment much easier.

The finger loops can be swapped from side to side to match your scissors, depending on which way the blades overlap.

Your scissors must be made of steel which magnets can stick to. Cotton gloves are a help too, to help you hold the film in place and avoid fingerprints/grease.

This 3D-printed guide works to keep your film and scissors at a 90 degree angle, and helps to make the edge of the frames easier to spot so you can cut it in the right place. Can be used over a table with a film strip, or with the strip hanging up (my preferred way to cut film).

The jig uses five neodymium magnets to hold the scissors in place, making their alignment much easier.

The finger loops can be swapped from side to side to match your scissors, depending on which way the blades overlap.

Your scissors must be made of steel which magnets can stick to. Cotton gloves are a help too, to help you hold the film in place and avoid fingerprints/grease.

Shop

Contact

Policies